Nintendo Switch repair
Nintendo Switch repair done right, down to the board
From the original Switch and Switch Lite to the OLED and the new Switch 2, we fix the faults that take consoles out of action: Joy-Con stick drift, cracked screens, dead USB-C charging ports, consoles that won't power on, and units that overheat or refuse to send video to the TV. Many of these are board-level problems, not just part swaps, so we run an in-house microsoldering bench instead of mailing your console somewhere else. Every repair starts with a $65 written diagnostic that applies toward your fix, and we've been doing this honestly in Arlington for 11 years. Walk in, or use tracked mail-in from any of the 50 states.
Yes, WeFixed repairs the Nintendo Switch, Lite, OLED, and Switch 2 at the board level in Arlington, VA, including Joy-Con stick drift, cracked screens, dead USB-C charging ports, no TV output, no-power consoles, and tired batteries. We microsolder failed chips and ports in-house instead of swapping the whole unit. Every repair starts with a $65 written diagnostic that applies toward the fix.
Switch repair: WeFixed vs Nintendo vs Buy new
| What you get | WeFixed | Nintendo service | Buy new |
|---|---|---|---|
| Joy-Con drift fix | Module or board-level | Module swap | Not a fix |
| Board-level work | Yes, in-house | No | No |
| No TV output / USB-C | Reworked at board | Often whole-unit swap | Not a fix |
| Your save data | Kept on device | Risk of swap | Lost |
| Warranty | 1 yr OEM / 30 day aftermarket | Varies | Manufacturer |
Carriers and stores swap the whole console; we fix the actual failed part.
Every Nintendo Switch fault, repaired right.
Joy-Con stick drift
Characters that move on their own are the most reported Switch fault. We replace worn stick modules and, when the fault is on the controller board itself, microsolder the Joy-Con analog rail rather than tossing the unit.
Cracked or dead screen
Drops crack the glass and LCD or OLED panel on the Switch, Lite, OLED, and Switch 2. We fit correct-spec panels so touch, brightness, and color match how the console left the factory.
Won't charge / USB-C port
The USB-C port takes daily abuse from charging and docking, so loose or dead ports are common. We do true board-level port replacement and repair lifted pads and charging ICs underneath.
No video out to TV
A console that runs handheld but shows nothing on the TV usually points at the USB-C port or the video output IC in the dock path. We trace and rework the failed component instead of guessing at the dock.
Won't power on / overheats
Dead consoles, no-boot units, and overheating that shuts the system down often trace to the power circuit or a failing chip. We diagnose at the board level to find the real cause.
Battery won't hold a charge
Short playtime, swelling, or a unit that dies off the dock points to a tired battery. We install fresh cells and verify safe charging before the console goes home.
Pick the repair you need.
Nintendo Switch repair, answered honestly.
Can you actually fix Joy-Con drift for good?
My Switch works handheld but won't show up on the TV. What's wrong?
Do you repair the Switch 2 and OLED, not just the original?
How much does a Switch repair cost and how long does it take?
Ready to fix your Nintendo Switch?
Most quotes come back within 15 minutes. Walk in to Arlington or mail it in from anywhere in the US.